SOTA outings by KØMOS and contributors

Tag: Platte River Mountains

  • W0C/SP-061 (Payne Benchmark) – 3591 m / 11780 ft

    W0C/SP-061
    Payne Benchmark
    3591 m / 11780 ft
    First Activation
    Oct 27, 2016

    By KX0R

    Payne Benchmark is a fine SOTA peak in the wilderness near Bailey, Colorado.

    Key Points:

    Pike National Forest
    • Platte River Mountains
    Lost Creek Wilderness
    • Good marked trail much of the way
    • Off-trail final climb, about 0.6 mile to a pleasant summit
    • Nice scenery – wilderness
    • Summit is rarely visited
    • ~ 15.5 miles round-trip
    • ~ 3750 vertical feet
    “SOTA Classic”

    Driving Directions:

    • Drive west from Denver via Highway 285 to Bailey
    • Turn south on CR 64, at a bridge next to the lumber-yard
    • Where the road forks, continue left, mostly west on 2WD dirt road CR 64
    • After about 2 miles, look for Payne Gulch Road on the left (closed to public)
    • Drive past Payne Creek on CR 64 about 0.2 mile
    • Turn left, south, on a small forest road, and continue about 100 yards to the parking area
    • Park here – this is the Brookside-McCurdy Trailhead
    • There is no charge to park or enter
    • Google Maps shows the roads in this area OK

    The Hike and the Climb:

    • Google Maps only shows fragments of the trails here – the Trails Illustrated/National Geographic maps are much better.
    • The trail first leads roughly south – it’s not very efficient, because it was built to bypass private land.
    • At about one mile from the trailhead, the trail splits.
    • Head southwest on Brookside-McCurdy Trail 607.
    • Follow Trail 607 as it leads across a small creek, crosses a large ridge, and climbs high into the Lost Creek Wilderness.

    • The trail continues up McArthur Gulch and gains plenty of vertical feet.
    • Eventually the grade moderates, and the route reaches a broad saddle at about 11,250 feet, near the crest of the Platte River Range.
    • Be sure you have a good map and/or a GPS unit with topo map data for the final off-trail climb
    • Leave the trail and head southeast into the forest – the summit is not visible
    • Hike steeply up the slope toward the peak – the exact route is not critical – it’s about 500 vertical feet to the top.

    • The route ascends to a broad bench at 11,600 feet – this area is covered with young bristlecone pine trees

    • Climb east from the bench, up through a thick forest of much older bristlecone pines, and finally up a few rocks to the craggy summit.

    Details:

    The summit’s small, but it has a convenient flat spot right at the top. A few live and dead trees are available for supporting a pole or a wire. Since the weather was perfect, I decided to set up right next to the summit block, so I guyed my pole to the rocks.

    I tied the far end of the wire to an erect dead tree, the old SOTA trick for a second pole! Payne Benchmark is a near-perfect HF radio site – very prominent and RF-quiet. I logged 48 CW contacts on 4 HF bands during my activation.

    UHF/VHF coverage probably is significant, because the peak looks east across lower mountains to some large areas out on the plains.

    The peak feels even higher than it is. The vast, open views into the Lost Creek Wilderness reveal peaks and other features not visible from the highways in the valleys below.

    Many SOTA peaks are visible. Lost Platte Peak stands a few miles to the east, and Pikes Peak is visible in the south. Windy Peak and Buffalo Peak are not far away; Green Mountain, Wellington Lake and The Castle stand far below! South Twin Cone and North Twin Cone command the western view, along with higher peaks on the Divide further west. Peaks X and Y stand right across the immense glacial valley of Craig Creek that runs 1000 feet down below.

    These views pulls you in – the more you look, the more you see. As a relative newcomer to the Lost Creek Wilderness, I was stunned by the vastness and intricacy of the views. This is true wilderness – there’s no one else – and it’s all perfect and incredible – for too short a time. Only the radio connects you to civilization.

    Payne Benchmark is a true “SOTA Classic”. The excellent challenging hike, the fine scenery, the pure wilderness, the summit climb through the bristlecone pines, the small rocky summit looking out across incredible views for miles in every direction, and the perfect radio site make this one of the best SOTA peaks around!

    Save this summit for the best day you have free.

    Please don’t visit this summit when cumulus clouds threaten. It’s certainly a dangerous place in a storm. The tiny summit is the highest point for miles, and it’s just reaching up toward the clouds for a lightning strike. Most of the central trunks of the old bristlecone pines there have been struck and killed hundreds of years ago – it’s obvious. Only a few branches are still alive on some – and many others are all dead.

    Lost Platte Peak W0C/SP-086 is only about 4 miles east of Payne Benchmark, and it might be reached by hiking along the heavily-forested top of the Platte River Range, but activating both peaks in one day would be difficult.

    Lost Platte Peak can also be reached from the same trailhead as Payne Benchmark, via the Payne Gulch Trail 637.

    73

    George
    KX0R


    ATTENTION !! WARNING !! There are old mountaineers, and bold mountaineers… there are no old-bold mountaineers. Hiking and mountain climbing are potentially hazardous activities particularly in Colorado with its extreme elevations. I am not accepting responsibility for any death or injury resulting from activations based on my trip reports. Proper training, experience, and personal capability assessment is required – enjoy!

  • W0C/SP-086 (Lost Platte Peak) – 3248 m / 10657 ft

    W0C/SP-086
    Lost Platte Peak
    3248 m / 10657 ft
    First Activation
    Oct 14, 2016

    By KX0R

    Lost Platte Peak is a fine SOTA peak in the wilderness near Bailey, Colorado.

    Key Points:

    Pike National Forest
    • Platte River Mountains
    Lost Creek Wilderness
    • Good marked trail much of the way
    • Off-trail final climb, about one mile to a pleasant summit
    • Nice scenery – wilderness
    • Summit is seldom visited
    • ~ 12 miles round-trip
    • ~ 2500 vertical feet

    Driving Directions:

    • Drive west from Denver via Highway 285 to Bailey
    • Turn south on CR 64, at a bridge next to the lumber-yard
    • Where the road forks, continue left, mostly west, on 2WD dirt road CR 64
    • After about 2 miles, look for Payne Gulch Road on the left
    • Payne Gulch Road is gated and closed to the public
    • Drive past Payne Creek about 0.2 mile
    • Turn left, south, on a small forest road, and continue about 0.1 mile to the parking area
    • Park here – this is the Brookside-McCurdy Trailhead
    • There is no charge to park or enter
    • Google Maps shows the roads in this area OK

    The Hike and the Climb:

    • Google Maps only shows fragments of the trails here – the Trails Illustrated/National Geographic maps are much better.
    • The trail first leads roughly south – it’s not very efficient, because it was built to bypass private land.
    • About one mile from the trailhead, the trail splits.


    • Head left, southeast, on Payne Gulch Trail 637. This trail is less traveled than Trail 607.
    • Follow Trail 637 as it leads toward Payne Creek and up into the Lost Creek Wilderness.


    • The route climbs along old logging roads to a broad pass or saddle.


    • It’s over 4 miles from the trailhead to the pass at 9900 feet:


    • At the pass, leave the trail and climb east-souteast through aspens
    • Ascend the nearby ridge at about 10,100 feet, and follow the ridge southeast toward Lost Platte Peak.

    • It’s more than 1 mile from the saddle at 9900 feet to the summit.
    • The ridge is mixed aspen and conifer forest, with some deadfall.
    • Most of the route is easy, with useful game trails.
    • Climb over a small sub-peak at about 10,280 feet, and Lost Platte Peak comes into view.

    • The final climb to the summit is about 500 vertical feet – just follow the ridge; stay slightly left, north, of any craggy spots.

    Here’s an excellent report on a winter expedition to Lost Platte Peak.

    Details:

    Lost Platte Peak has several rocky points, and they’re all in the large activation zone. Many trees are available for holding a pole or a wire. Because of wind, I set up slightly below the top in a nice aspen grove.

    The peak is a fine HF radio site – very prominent and RF quiet. I logged 58 CW contacts on 4 HF bands during my SOTA first activation.

    UHF/VHF coverage probably is limited to the area around Bailey, plus a few places out east.

    The peak feels very high when you’re up there. The open views into the Lost Creek Wilderness reveal peaks and other features not visible from the highways around the area. Windy Peak W0C/SP-056 and Buffalo Peak W0C/FR-032 stand high in the southeast; Wellington Lake and The Castle W0C/FR-161 stand far below!

    The summit of Bison Peak W0C/FR-021 stands behind other mountains. There’s even a glimpse of the Plains far to the east, as well as a few peaks on the Divide in the west.

    Despite being so close to the Denver Metro Area, the Payne Creek Trail leads to some wild country not visited by the masses. This is a special place; it provides intense solitude and wonderful vistas for the fortunate few who go up there.

    Payne Benchmark W0C/SP-061 is about 4 miles west of Lost Platte Peak, and it might be reached by hiking along the top of the Platte River Range; but activating both peaks in one day would be very difficult. Payne Benchmark also can be climbed from the same trailhead as Lost Platte Peak, via Brookside-McCurdy Trail 607.

    Mount Bailey W0C/FR-062 is only a few miles east of the Brookside-McCurdy Trailhead, and it’s a practical second summit to combine with Lost Platte Peak for a dual activation.

    73

    George
    KX0R


    ATTENTION !! WARNING !! There are old mountaineers, and bold mountaineers… there are no old-bold mountaineers. Hiking and mountain climbing are potentially hazardous activities particularly in Colorado with its extreme elevations. I am not accepting responsibility for any death or injury resulting from activations based on my trip reports. Proper training, experience, and personal capability assessment is required – enjoy!